Copyright © 2016 - HAKE GmbH. All Rights Reserved.
Choice of the appropriate type of spray ball depends on the following
particulars:
distance of the device from the walls of the tank, installation depth,
tank dimensions, type of detergent, pump specifications and tank use
A good advantage of the HAKE - spray balls is that we have a range from:
DN8 bis DN50
It is possible to use the spray ball optimal and efficient.
•
Perigon spraying 360° is required for strongly soiled containers
and difficult to remove stains. This type of spraying ensures
direct impact of the cleaning fluid and makes every spot of the
tank accessible.
•
For low level soiling semi-angle spraying 180° upwards is
sufficient. The lower portion of the tank is cleaned indirectly by
cleaning fluid flowing down the sides of the walls.
•
If there are any fixtures inside the tank that require special
attention, an additional installation of a semi-angle spraying
device 180° downwards is recommended. This device can be
installed alternatively either directly above or below the fixtures
in question.
Installation for
HAKE-Sprayballs
Our spray balls find the optimal use in the low-pressure region between
0,5 bar and 3,0 bars.
On reason for our long experience we recommend the following
installation deep for our spray balls: :